Low Voltage

BlueSCSI will log the voltage on power up - normally should be around 3.2-3.3V. If it detects a voltage below 2.8V it will not work reliably and will log:

WARNING: Detected voltage drop to 2.74V - See: https://www.github.com/BlueSCSI/BlueSCSI-v2/wiki/Low-Voltage

Things to try to solve the low voltage:

• If you are powering via the bus, check the voltage of the TERMPOWER pin. It should be approximately 5V.
• Use a different power source such as the Berg connector or USB adapter plugged into the Pico.

This wiki has been updated 817 times by 76 people like you!
Click here to edit this page.
Generated 2025-05-14